Cabochon Mold 737 - 6 Cavity would be great to create resin jewelry or paperweights or to decorate bottle tops. These domes are slightly flattened on top. (Imagine a biscuit -- puffed up in the center, but not quite a half sphere) This mold holds about 4 oz of resin when filled. Each Cabochon dome is approximately 1 7/8" diameter and 1/2" deep.
How to Use Resin Molds: Remove any dust and particles from your reusable mold. Molds do not require mold release when casting with resin, however, it is strongly suggested. We recommend the use of Castin' Craft Mold Release and Conditioner. Protect your work area with freezer or wax paper. Treat mold with mold release and allow to dry. Place mold on a level surface and fill the cavities to just below the top. Once the pieces are cured, turn the tray over and press the center area of each piece while flexing to release the casting. Do not use sharp objects to demold your resin as you will scratch your mold. Be sure to also read our plastic resin mold care tips to ensure a long life for your molds.
I like it not being a full half circle with a "flatter" side but it shipped quite warped, had to fasten to bench when I poured to hold it flat.