Create beautiful resin tiles or paperweights with this mold. Castings will measure approximately 3 inches square and 3/4 inches deep. Casting will taper in 1/2 inch from bottom to top side. Mold will hold approximately 2 1/2 ounces of resin when filled.
How to Use Resin Molds: Remove any dust and particles from your reusable mold. Molds do not require mold release when casting with resin, however, it is strongly suggested. We recommend the use of Castin' Craft Mold Release and Conditioner. Protect your work area with freezer or wax paper. Treat mold with mold release and allow to dry. Place mold on a level surface and fill the cavities to just below the top. Once the pieces are cured, turn the tray over and press the center area of each piece while flexing to release the casting. Do not use sharp objects to demold your resin as you will scratch your mold. Be sure to also read our plastic resin mold care tips to ensure a long life for your molds.
being new to casting and now have experimented with all plastic, silicone, and mold putty, the plastic molds are by far the best. The silicone I just cannot get rid of all the bubbles under the same conditions, and the putty I have not had good luck at all even when baked. limited success with the pourable silicone, still testing. Using R E's clear resin and plastic molds I have turned out glass clear bubble free casts just warm the bottles if your up north. Good luck!